Manzano Laser Works
WACO SRE
Home
Laser Cutting
Laser Engraving
Airplane Kits
Accessories
Photo Gallery
Frequently Asked Questions
Downloads
Videos
Contact us
LINKS

(Back to Kits)

WACO SRE designed by Peter Rake

sreside.jpg
srerear.jpg
srefly1.jpg

srefly2.jpg

srefuse.jpg

srewings.jpg

INTERMEDIATE LEVEL KIT

A Peter Rake design airplane featured in Flying Scale Models as a free plan issue. Prototype built and flown by Charlie Bice.

The WACO SRE is a classic design that is beautiful in flight or on the ground. Every SRE that I have seen fly has the same great flying characteristics that make it a good plane for an intermediate pilot and this one is no exception. Well suited to flying from a runway, it is a bit fast for grass landings unless the grass is very short.

The construction is typical of Rake designs with a box front fuselage and framed rear section. A straight fuse is easy to obtain and is very strong. A roomy cabin area allows easy access to radio gear and a wide range of battery locations to obtain the proper CG.

The design power package is the Olympus geared sp400. The plane flies well on the sp400, but, the prototype (which came out a bit on the heavy side at 24oz) flew even better on the sp480. My second SRE is powered with a Hacker A20-30M outrunner.

Control can be either 3 or 4 channel. The dihedral in the kit is adequate for good control using R/E/T alone. Adding ailerons requires two additional servos (small ones), one in each wing. Aileron control gives good crisp response. Moderate aerobatics are possible, loops, barrel rolls, snap rolls, and wing overs can be performed easily. Aileron rolls are near impossible as roll rate with just ailerons if very slow.

The short kit includes vacuum formed cowl and wheel pants. The full kit includes the plastic cowl and wheel pants, plus the plastic windshield material, wires, sticks and sheet necessary to finish the plane. Pink foam is included for carving fill blocks. No wheels are included in the kit. There are crude instructions in the full kit (and can be downloaded from the downloads page).

Specifications:
Wingspan: 38"
Length: 31"
Weight: 20 oz
Wingarea: ~310 sqin

Recommended power:
Speed400
Olympus 2.33:1 gearbox

Optional power:
Hacker A20-30M
2s or 3s 2100 LiPo
10x7 APC E prop

Other power:
EFlite 400/450 or similar
sp480 geared
inexpensive bell motors

WACO SRE
Parts only (including plastic parts) ($39.95).
Parts and Plans ($49.95).
Full kit ($64.95).

  Item Total >  

International Shipping click here

(Back to Kits)

charlie@manzanolaser.com (505) 286-2640